Protech-audio MX405 Bedienungsanleitung PDF herunterladen

PROTECH

WWW.PROTECHAUDIO.COM

1/05

Protech Audio Corporation, PO Box 597, 192 Cedar River Road, Indian Lake, New York, 12842, Voice 518-648-6410 Fax 518-648-6395

All Quicktrack products use a consistent ground scheme. The MXT-1 power supply provides the

necessary ground conductor. Power supplies without the 3rd conductor ground should not be used

with Quicktrack products.

CAUTION: Do not plug power supply into AC receptacle until the secondary conductors have been

attached to the Quicktrack module. Doing so may cause the power supply conductors to short and

damage the supply.

Installion steps for the Quicktrack modules are as follows;

1- Remove the cover screw (All modules except MX410) and cover.

2- Press down on the lower edge of the Quicktrack mounting extrusion until the lower edge of the

printed circuit assembly comes free.

3- Slip the printed circuit assembly out of the upper edge of the mounting extrusion.

4- Mount the Quicktrack mounting extrusion in an appropriate location, away from moisture, heat

sources, and AC fields.

5- Connect all audio connections to the barrier connector using double conductor shielded cables

designed for low level audio signals. Do not use multiple solid conductor cables.

6- Connect the 3 power supply conductors to the power supply connection points on the barrier

connector.

7- Plug the power supply into an AC receptacled.

8- Check for proper illumination of the LED power indicator.

9- Adjust all audio levels as necessary.

10- Mount the cover onto the Quicktrack module being careful not to over-tighten the mounting

screw.

All initial adjustments on the MX405 are made at the factory. If after installing the unit higher or lower output

levels are desired, adjust outputs using trimpots as indicated.

The Model MX405 has one microphone input and four line

outputs. The microphone input incorporates a 15 volt phantom

power circuit, which is activated by a push-on jumper. The

input gain can be increased by 10dB by removing push-on

shunt at JP3. The outputs have adjustable gain.

All inputs and the output are electronically balanced. The

outputs may be used in either a balanced or unbalanced

configuration. Requires low voltage AC power (See MXT-1).

MODEL MX405

+15VDC

JP3, Off = +10dB

PHANTOM

INSTALLATION & OPERATION

MANUAL

MX405 AUDIO DISTRIBUTION AMPLIFIER, Rev. A

1 2

WWW.PROTECHAUDIO.COM 1

Inhaltsverzeichnis

Seite 1 - WWW.PROTECHAUDIO.COM

PROTECH®WWW.PROTECHAUDIO.COM1/05Protech Audio Corporation, PO Box 597, 192 Cedar River Road, Indian Lake, New York, 12842, Voice 518-648-6410

Seite 2

Protech Audio Corp. 192 Cedar River Road, Indian Lake, New York 12842 Voice 518-648-6410 Fax 518-648-6395PROTECH®INSTALLATION & OPERATIONMA

Verwandte Modelle: MX402 | MX401 | MX403 |

Kommentare zu diesen Handbüchern

Keine Kommentare

Protech-audio MX405 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Audio Protech-audio MX405 herunter. Protech Audio MX405 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: MX402 | MX401 | MX403 |

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio Protech-audio MX405